708-1W-00882 Main Hydraulic Pump for Komatsu WA380-6 WA430-6, 41570

Descripción del producto:

Pieza: 708-1W-00882 main hydraulic pump for the Komatsu WA380-6 and WA430-6 wheel loaders, with 708-1W-41570 listed alongside it for the same application.

Circuito: implement hydraulics. The folder label calling this a fan pump is not supported by any source we could check.

Suministrada como: reemplazo nuevo de marca HTD, fabricado en China. MOQ 1 pieza, caja de madera, despacho de 5 a 8 días hábiles.

Descripción

Two numbering blocks, one machine. 708-1W-00882 and 708-1W-41570 sit far apart in Komatsu’s numbering sequence, which usually means they are not two revisions of the same item, and no source we could find documents a link between them. We publish both numbers on this page and quote against your plate photograph.

Aplicabilidad y evidencia

Komatsu WA380-6 and WA430-6 wheel loaders, listed in trade parts data as the main hydraulic pump. Komatsu’s own online catalogue returns no page for either number, so the item name is trade-established rather than manufacturer-confirmed, and no displacement, pressure or flow figure is published for it here. The 708-1x prefix is consistent with a pump in Komatsu’s hydraulic group; the fan pump and the steering pump on the same machine are separate items, listed separately.

Three pumps, one loader

On a WA380-6 the hydraulic side is split three ways, and knowing which one is failing is the whole ordering question:

  • Main pump (this item) drives the boom, bucket and steering priority. Wear shows as slow cycle times and long fill.
  • Steering pump 708-1U-00170 feeds the articulation circuit. Wear shows as heaviness at idle.
  • Fan drive pump manages cooling only. Wear shows as temperature with normal digging performance.

Diagnosis and fitting

Measure implement pressure and flow at working temperature, then check relief settings and the priority divider before condemning the pump. Inspect the oil: glitter means a flush and a filter change, not just a new pump. On fitting, match shaft spline, pilot, flange, port positions and control orientation against the removed unit, prime the casing with clean oil before cranking, keep the case drain unrestricted to tank, change the return filter element, and target ISO 4406 18/16/13. Our guía del comprador de bombas y especificaciones covers the comparison method.

Pedido

Pedido mínimo una pieza. Garantía de tres a seis meses en unidades nuevas del mercado de repuestos según lo indicado en su factura proforma. Verificada en banco y fotografiada contra su pedido antes de cerrar la caja de madera, entrega de 5 a 8 días hábiles desde el pago sujeto a existencias. La gama se encuentra bajo Bomba hidráulica Komatsu.

¿No encuentras una pieza? ¿Necesitas que te la enviemos hoy mismo? Pregúntanos ahora.

Indica tu modelo o número de serie a continuación para recibir un presupuesto definitivo; a menudo, el envío se realiza el mismo día.